© Norsat International Inc. (“Norsat”) All Rights Reserved
2021-12-20 DOC-001527 Rev A 22
4. The “LOG OUTPUT” at the bottom of the page displays “Initialization complete” once all
data is received from the ODU.
3.6.2 Device Info Page
The device Info page will show the current status of the RSW system.
The Identification section will show the device configuration, serial number, firmware version,
and LNB model. In the case that the LNB being used is not a Norsat LNB, the LNB Model will be
set to “UNKNOWN”.
The Status section will show the Active Device (LNB1/LNB2), the Standby Device
(LNB1/LNB2), the Operation Mode (Automatic/Manual Override Mode), and the current ULC
status (DISABLED, BAND1, BAND 2, BAND 3 or BAND 4).
To Next Page