Need help?Do you have a question about the Norstar T7000 and is the answer not in the manual?
General| Display | 2-line LCD |
|---|---|
| Speakerphone | Yes |
| Headset Jack | Yes |
| Speed Dial | Yes |
| Ring Tones | Multiple |
| Volume Control | Yes |
| Compatibility | Norstar PBX Systems |
Listen to music via telephone speaker when not on a call.
Check programmed buttons for labels.
Display approximate length of current or most recent call.
Send calls to another telephone in your system.
Put a call on hold for pickup from any telephone using a retrieval code.
Answer any ringing telephone by dialing the extension number.
Answer a call ringing at another telephone in your pickup group.
Answer the next call when multiple calls are waiting.
Re-route a call to another telephone even if its lines are busy.
Change dialing filters or gain external access by entering a password.
Establish a conference call between yourself and two other parties.
Adjust the contrast of your display using a numerical code.
Choose one of three methods for dialing calls.
Prevent all incoming calls, except priority calls, from ringing.
Use both handset and speaker simultaneously during a call.
Temporarily suspend a call. Retrieve by pressing the line button.
Select primary or alternate languages for the telephone display.
Automatically redial the last external telephone number dialed.
Share several lines for making calls using a line pool access code.
Send calls arriving on an external line to another telephone.
Generate a Link signal to access a PBX or other host exchange.
Generate a tone for as long as a button is held down.
Send a message to another telephone within your system; view and reply to messages.
Change the position of line or hunt group buttons on the telephone.
Block outgoing name and/or number on a per-call basis.
Program a 1.5 second delay into an external autodial sequence.
Interrupt a person who is on a call.
Change the privacy setting for an external line to allow or prevent others from joining your call.
Monitor a busy or unanswered telephone and be signaled when it becomes available.
Select a distinctive ring to differentiate between telephones.
Adjust the telephone's ring volume or volume during a call.
Store multiple autodial numbers or feature codes on one button with break points.
Save a number to redial later, or redial a previously saved number.
Show or activate alternative ringing/call answering arrangements.
Activate services for restrictions on specific lines or telephones.
Activate services for routing on specific lines or telephones.
Monitor members of a hunt group if your telephone is designated as a supervisor.
Dial an external telephone number using a three-digit code.
Change the first line of the display to the current time and date.
Briefly display the time and date while on a call.
Send a call to another telephone within or outside the system.
Answer an external call placed into a Ringing Service schedule.
Make a voice announcement or start a conversation through another telephone's speaker.
Prevent your telephone from receiving voice calls.
Program an external autodial number to wait for dial tone from another system.
Automatically delete the oldest log item from a full Call Log to store new items.
Display name, number, or line name of ringing or held calls.
Log displays special characters for new, answered, long distance, or shortened items.
Erase a specific entry from the Call Log.
Redial a number directly from the Call Log.
Select types of calls to be automatically stored in your Call Log.
Program a four-digit password for your Call Log.
Store caller information for your current call in your Call Log.
Store caller information on the service provider system for the last external call.
To Next Page
