Start Up | 38
Multi Mode (NHTC Only)
Start up of each humidifier configured and installed for multi mode operation is the same as
starting up standalone humidifiers with the exception that for the humidifier to fill and produce
steam the demand to the master unit must be greater than the Multi Unit Op. Range setting of
the unit being started. (Example for a slave unit configured to operate between 20 and 30% the
demand to the master must be greater than 22%)
Each unit connected in a multi mode system will display its demand as a percentage of the
range for which it is configured. Example, a slave unit configured to operate between 20 and
30% demand will display a demand of 50% when demand to the master is 25%.
Note: See Multi Unit Op. Range on page 54 for software configuration, and Multi Mode Wiring
on page 28 for wiring of humidifiers in a multi mode system.
NORTEC LINKS 2 (NHTC Only)
NORTEC LINKS 2 is an option that can be integrated with the NHTC. It allows a Building
Management System to monitor and / or control the humidifier. For complete information about
NORTEC LINKS 2 and its operation and configuration, go to www.humidity.com and look up the
NORTEC LINKS 2 manual.
NORTEC ONLINE (NHTC Only)
NORTEC ONLINE is an option that can be integrated with the NHTC. It allows a user to log onto
the Internet, go to www.norteconline.com and log in to allow them to monitor their unit from any
computer with an internet connection. It can also be configured to send service reminders and
fault warnings when they occur.
To Next Page
Loading...
Need help?
General
