To Next PageTo Next Page
Need help?Do you have a question about the Nortek VP7RE Series and is the answer not in the manual?
General| Series | VP7RE |
|---|---|
| Refrigerant | R-410A |
| Energy Efficiency Ratio (EER) | Up to 12.5 |
| Cooling Capacity | 24, 000 - 60, 000 BTU/H |
| Heating Capacity | 24, 000 - 60, 000 BTU/H |
| Power Supply | 208/230V, 1 Phase, 60 Hz |
| Noise Level | As low as 55 dB |
| Dimensions (H x W x D) | Varies by model |
| Weight | Varies by model |
Addresses potential hazards related to electrical shock, fire, and explosion during installation and servicing.
Details warnings for R-410A refrigerant, emphasizing qualified personnel for charging and handling.
Highlights the importance of following local codes, using qualified installers, and avoiding unqualified service.
Covers load calculation, insulation, power supply verification, and unit inspection upon arrival.
Provides guidance on selecting a solid, level outdoor position, considering duct length, and avoiding confined spaces.
Specifies required clearances around the unit for unobstructed airflow and proper servicing.
Outlines standards for duct installation, including NFPA guidelines and ACCA methods.
Instructs on safely unpacking the unit and precautions against tipping to prevent compressor damage.
Details the process for positioning and securing supply and return air collars to the unit openings.
Provides steps for attaching the supply duct collar to the unit opening, ensuring a proper fit.
Explains how to assemble and attach the return air collar to the unit's rear panel.
Guides on locating and installing the return air box and grille, ensuring filter accessibility.
Covers connecting flexible ducts using clamps, minimizing length, and avoiding sharp bends.
Details the procedure for installing a supply damper in the furnace base to prevent cold air discharge.
Verifies voltage, frequency, phase, supply capacity, and factory wiring before making connections.
Details requirements for disconnect switches, dedicated circuits, and connecting field wiring to the unit.
Specifies the need for an uninterrupted electrical ground and how to connect it using the green grounding screw.
Recommends using the smallest fuse/breaker that allows normal operation while providing maximum protection.
Covers 24 VAC control circuit requirements, wiring routes, and thermostat mounting considerations.
A checklist of critical items to verify before initiating unit startup, including levelness and duct sealing.
Procedure to verify proper cooling function by setting thermostat and checking discharge air.
Procedure to verify proper heating function for units equipped with electric heat.
Details the method for checking and adjusting refrigerant charge using pressure and temperature measurements.
Explains the operation of high and low-pressure switches designed to protect the compressor.
Lists essential maintenance like filter inspection, cleaning coils, and checking electrical connections.
