North Alfred User Manual

ENGLISH
GREAT BRITAIN • CUSTOMER SERVICE
tel. 0845 300 9799 e-mail: customerservice@clasohlson.co.uk internet: www.clasohlson.com/uk
5
3
4
6
7
10
9
1
2
8
Ver. 20140528
Alfred Outdoor Lamp
Art.no 36-1425 Model EL-991DN
Please read theentire instruction manual before using theproduct
and then save it for future reference. We reserve theright
for any errors in text or images and any necessary changes
made to technicaldata. If you have any questions concerning
technical problems please contact our Customer Services.
Safety
• Warning: Alllight fittings must be installed in accordance with
current safety regulations to prevent life-threatening accidents.
• Theinstallation of this light fitting should only be performed
by someone with agood knowledge of electrical wiring.
• If in doubt, contact aqualified electrician.
• Follow theinstructions carefully and keep them for future
reference.
Description
1. Glassdiffuser
2. Shade
3. Wallbracket
4. Terminalblock
5. Wallplate
6. Retaining screws
7. Cap nut
8. Rubberseal
9. Metalwashers
10. Rubber washers
Installation
7. Connect thepower lead to
theterminal block as shownbelow.
- Brown or black (live) connects
to theterminal marked “L”.
- Blue (neutral) connects to
theterminal marked “N”.
- Yellow-green (earth) connects
to theterminal marked with
theearth symbol
.
Warning: Always turn thepower
off at thedistribution box before
installation (main power switch/
circuit breaker set to OFF, or fuse
completely disconnected).
Note: Thewall plate should be
mounted with themarked arrow
pointing upwards.
1. Remove the cap nuts (7) and rubber washers (10),
andremove thewall plate (5).
2. Measure out thearea where thelight will be mounted.
3. Thread thepower lead through thewall plate’s rubberseal.
4. Pushtheretaining screws (6) through from theback of
thewall plate before screwing it onto thewall.
5. Depending on wall type, you can either screw thewall
plate directly onto thewall or mark out and drill mounting
holes and use plugs for mounting.
6. Note: Therubber seal (8) should be pressed securely
onto thewall plate so that it forms aseal against thewall
bracket before mounting.
8. Mountthewall bracket onto thewall plate so that its
retaining screws protrude at thefront. Firstthread
therubber washers (10) over theretaining screws (6), then
themetal washers (9) and finally use thecap nuts (7) on
top to tighten everything together.
9. Remove theglass diffuser and screw in alight bulb (max
60W, E27) (sold separately). Screwtheglass diffuser back
on securely and turn on thepower.
Disposal
This product should be disposed of in accordance with local
regulations. If you are unsure how to proceed, contact your
local council.
Specifications
Model EL-991DN
Voltage 230 V AC, 50 Hz
Bulb Max 60 W, E27 (sold separately)
IP rating IP23
Shade Ø 30 cm

North Alfred Specifications

General

Brand	North
Model	Alfred
Category	Outdoor Light
Language	English