North Explorer 460 - Assembly Instructions; Assembly; Trampoline Placement

5
ASSEMBLY
The trampoline is to be assembled in accordance with the instruction manual by two or three persons of which
one should be an adult. Use gloves to protect hands and ngers from injury during assembly.
Any modications made by the consumer to the original trampoline (e.g. the adding of an accessory) shall be
carried out accoring to the instructions of the manufacturer.
TRAMPOLINE PLACEMENT
• Do not install the trampoline over concrete, asphalt, bricks or any other hard surfaces nor at proximity of
other conicting installations (e.g padding pools, swings, slides or climbing frames).
• Install the trampoline on a level surface at least 2 m from any structure or obstruction such as a fence, ga-
rage, house, play areas, overhanging branches, laundry lines or electrical wires.
• Above the trampoline there must be a minimum of 7 m clear space from ground level and up. Provide
clearance from wires, overhanging branches, or other obstacles.
• Normal trampolines with high legs should not be buried into the ground to become sunken trampolines.
• At least two adults are required to move the trampoline. To move it, stand on opposite sides of the trampo-
line. Lift the trampoline simultaneously and move it in the desired direction.
ENGLISH
ASSEMBLY INSTRUCTIONS
7m
2m
2m