27
Place the pedal in the desired position
onto the rail and tighten the rope in the
jam cleat.
Tighten it only that much, that you have
enough space to do perform the steering
movement. Then again lead the rope
through jam cleat.
Cut the surplus rope and seal the cut with
a lighter.
NOTE:
The jam cleats can stay on the steering
rope.
Last but not least install the pull-up cord.
First take the rope with the sliding clip and
knot it tight to the D-rings behind and in
front of the cockpit.
(The picture shows this step on the nortik
navigator)
To Next Page
Loading...
