15
5) Installation of the rudder system
The rudder system can be used on both sides of your nortik scubi 2.
Both, bow and stern
have a pickup for the rudder blade. This allows you to use the rudder system either in solo
use, or when paddling in pairs.
At the first assembling take the small
security ring (1.) off the rudder blade.
Then open the wing nut (2), put the
distance piece through the hole (3) and
reclose the wing nut.
Now place the rudder onto the cavity at
the stern and secure it with pin, by
pushing it through from above. Secure
the pin at the bottom again with the little
ring.
steering bar
Carabiner for
pull-up rope
Rudder blade
To Next Page
