11
The precisely manufactured blade shaft is fitted into two heavy-duty self-aligning pillow block
bearings, including grease nipples. On one end is a Poly-V pulley with taper lock and on the
other end the shaft is reduced to 25,4mm, allowing an inner flange to be fixed. Outer flange is
assembled on the shaft with a 36mm locking nut.
(A 20 mm thick spacer flange and an outer flange, with dowel pinholes, can be provided as
accessories)
The steel belt guard (5) is a sealed two piece unit. The backing plate is bolted to the mainframe
of the machine and locking nuts are welded to it. The outer guard, covering the Poly-V belt and
taper lock pulleys, is held in place by four locking bolts.
The 13 HP Honda GX390 engine (6) is connected to an emergency shut down switch (7) on the
right side of the machine near the levers. This allows an immediate stop of the machine in case
of danger.
The water cooling system (8) is composed of a 25 litre water tank, a water tank tap and two
water nozzles located on the blade guard ensuring adequate flow of water to both sides of the
cutting blade. This system can be connected directly to tap water too.
The pointers (9) allow the operator to make precise cut easily.
The set including front cutting guide, guide attached to blade cover, and rear cutting guide allow
to align easily and accurately blade with cutting line.
A hook (10) allows the CS 451 to be lifted in an easy and well balanced way.
Parking brake (11) secures the machine when it is not running.
To Next Page
Loading...
