8
While the engine is running
• Do not move the machine whilst the blade is running idle.
• Do not run the machine without the security guards in place.
• Apply cooling water continuously whilst cutting and in good time (even when dry cutting to
avoid dust)!
Petrol powered machines:
• Always use the fuel advised.
• In confined areas, exhaust gases should be evacuated and the job site properly aerated.
• Petrol and diesel machines, which by their nature emit toxic exhaust gases, must not be
used in places prohibited by the Health at Work etc. Act 1974 or which are prohibited by
Factory Inspectors or Safety Officers.
• Fuel is flammable. Before filling the tank, shut down the engine, extinguish all open flames
and do not smoke. Take care that no petrol is spilled on any motor part. Always wipe up
spilled fuel.
To Next Page
Loading...
