Why is my Norwood Farm Equipment plugging completely?
Your Norwood Farm Equipment may be plugging completely because the ground speed is too low. Increase the speed as specified in the operations manual. Alternatively, the working depth might be too deep. Set the depth to 2-3 inches in the spring and 3.5-4.5 inches in the fall.
What to do if Norwood Farm Equipment does not track straight?
If your Norwood Farm Equipment does not track straight, it might not be level from front to back. Adjust the hitch link height to the tractor drawbar. You can also add a depth stop to rear attachment cylinders or wheel strut cylinders. Reducing machine tracking spacing for more overlap or adjusting AutoTrac to the left or right might also help.
Why are wings plugging on my Norwood Farm Equipment?
If the wings are plugging on your Norwood Farm Equipment, ensure that the main and wing cylinders are in float and that cylinder stops are consistent with the main frame. Also, try reducing the digging depth and reducing the speed to 10.5 mph (17 km/h).
What to do if there is furrow on the left side with Norwood Farm Equipment?
If you notice a furrow on the left side when using your Norwood Farm Equipment, it could be due to the soil not filling the cut. Try increasing the machine speed to 10.5 mph (17 km/h). Additionally, adjust the deflector towards the rear rank and ensure that the deflector is not running in the soil.
Why is the surface finish unsatisfactory with my Norwood Farm Equipment?
If the surface finish is unsatisfactory when using your Norwood Farm Equipment, the speed might be too low. Increase the machine speed to 10.5 mph (17 km/h).
What causes subsurface ridges with Norwood Farm Equipment?
Subsurface ridges when using Norwood Farm Equipment can be caused by the machine being unlevel. Verify that the depth stops and hitch link are adjusted properly.
What to do if deflector is plugging on Norwood Farm Equipment?
If the deflector is plugging on your Norwood Farm Equipment, it may be due to too much residue. During Fall tillage or in high residue conditions, flip the deflector up.
How to improve residue flow with Norwood Farm Equipment?
To improve residue flow with Norwood Farm Equipment, adjust the front rank. In high residue conditions, it may be necessary to raise the front rank.
Why is the folding sequence slow on my Norwood Farm Equipment?
A slow folding sequence on your Norwood Farm Equipment may be due to low hydraulic pressure or flow from the tractor. Verify the SCV settings and fluid levels.
What to do if my Norwood Farm Equipment is not folding at all?
If your Norwood Farm Equipment is not folding at all, check for hydraulic connection issues. Verify that all hoses are connected properly and that hose pairs are mated correctly. Refer to the hose chart on the machine. If the hydraulic fluid is bypassing piston seals in one or both hydraulic cylinders, replace the cylinder or rebuild it with new seals.
General| Brand | Norwood |
|---|---|
| Model | Kwik-Till HSD3500 |
| Category | Farm Equipment |
| Language | English |
To Next Page