Notifier INA - Page 61

INA 15092:I 05/30/01
61
2.1 PARTIAL SYSTEM PROGRAMMING D }X1X
The Partial System Programming menu has the following seven options:
1=NFN NOTIFIRENET - Changing the node address, selecting communication threshold,
specifying groups and linkages and selecting the network configuration.
2=KEY Keyswitch - Enable or disable the INA keyswitch input.
3=CABLE Power Supervision Cable - Enable or disable the INA power supervision cable.
4=ANN Annunciator Module Programming - Install or remove annunciator (EIA-485) devices
from the INA.
5=UDACT Universal Digital Alarm Communicator Transmitter-Program and specify the base
annuniciator protocol address in the system.
6=EXTEQ External Equipment - Change any optional features associated with the CRT monitor,
printer(s), Page-1 interface, or the modem interface.
7=LOCP Local Parameters - Selectively programs the INA for either Block Acknowledge or
Receiving Unit Mode operation.
Figure 2.1-1 Partial System Programming Menu Flow Chart
1 = PSYS
Select Partial
System
Programming
Options 1-7
1 = NFN
NOTIFIRENET
2 = KEY
(Keyswitch)
3 = CABLE
(Power Supervision
Cable)
4 = ANN
(Annunciator Module
Programming)
5 = UDACT
(UDACT Programming)
6 = EXTEQ
(External Equipment)
7 = LOCP
(Local Parameters)
www.PDF-Zoo.com