21
127-0919-001
Appendix
Using the included knockout bar accessory
The included knockout bar is a tool which is intended to be used for removing the Morse Taper accessory
attached to the lathe spindle.
To remove the Morse Taper accessory from the lathe
spindle by using the knockout bar:
1. Insert the knockout bar from the headstock
handwheel side.
2. Using a soft hammer to firmly strike the knockout
bar towards the tailstock side to knock any Morse
Tapered tools out.
Tip: Be cautious when striking the knockout bar
with a metal hammer as it will potentially crack the
plastic head on the bar.
To Next Page
Loading...