To adjust the handle height
1.
After the handle height has been
selected turn the knob clockwise
to tighten. Ensure the knob is fully
tightened into the groove on the
handlebar before operating the unit.
The handle bar should not move after
it has been fully tightened (see Figure
11).
Turn the knob counter-clockwise to
loosen the handlebar (see Figure 9).
2.
Set the correct adjustment
height for the end user by
moving the handle up or down
to the appropriate numbered
line on the handle bar (see
Figure 10). Please also review
“How to properly t your
walker”.
3.
Figure 9
Figure 10
Figure 11
Operation Instructions
To Next Page
Loading...
