NOVAK PIT WIZARD - Page 17

17 PIT WIZARD INSTRUCTION MANUAL
4. From the start-up screen on the Pit Wizard, press the {MODE}
button once. The display will read:
1 Upload Data
The number “1” indicates menu item one.
5. Press the {ENTER} button to upload the default parameters from
the Cyclone speed control. When the parameters have been
uploaded the display will read:
1 Upload Data
***DONE***
7. Press {MODE} button to move to the Edit Profile Mode.
Note: If at any time during Uploading, Downloading, or Monitoring
Tranmitter Trigger the display reads “COMM ERROR”, press and hold
the {MODE} button until you hear a steady tone, then release. You will
exit back to the Pit Wizard’s start-up screen, no Profile data will be lost.
UPLOADING PARAMETERS (CONT.)