Draugystės str. 15D,
LT-51227 Kaunas, Lithuania
www.novameta.lt
Phone: +370 37 302330
Fax: +370 37 302339
E-mail: novameta@novameta.lt
9
Fig. 3. Air gap left for circulation Fig. 4. The ventilation holes inside the heated cupboard
In places where warning triangles and/or screws are used to secure covers around electrical
parts, there is a risk of severe injury if covers are removed. Therefore, covers must only be removed by a
service technician only.
3.3. Electrical connection
All the heated units are tested by producer to assure proper operation. Power must be connected via a
wall socket. The wall socket should be easily accessible.
WARNING!
This heated cupboard must be earthed. Connecting the unit to the improper power source can cause
damage to the unit and invalidate the warranty.
All earthing requirements stipulated by the local electricity authorities must be observed. The heated
cupboard plugs and wall socket should then give correct earthing. If in doubt, contact your local supplier
or authorized electrician.
The heated cupboard is intended for connection to alternating current. The connection values for voltage
(V) and frequency (Hz) are given on the name plate.
Fig. 5. The nameplate
To Next Page
Loading...