BEFORE OPERATION
Check Oil – Engine will not operate with incorrect oil level (P. 16-17).
Check Fuel Level and move fuel cap vent to ‘ON’ position – Starting with
a full tank will help to eliminate or reduce operating interruptions for
refueling.
Check Eco-Mode switch* – Switched to off position
Check Loads - The generator may be hard to start if a load is connected.
It is recommended that all loads are disconnected from generator during
start.
Fuel Type – Ensure fuel type selector switch is set to correct fuel. If
switching fuel type, see P. 12-14 of this guide for fuel changing
procedure.
Note: – JP-8/F-24/Jet-A/Kerosene-1 are primary fuels for this generator.
Generator will run optimally on these kerosene-based fuels.
Check Air Filter – Check air filter per the maintenance schedule (P. 16).
Helpful hints:
Oil level: Engine will not operate if oil level is too low OR too high. Fill oil
to correct level (see P. 16-17). If many attempts to start are made with
inadequate or too much oil, spark plug may become fouled. Spark plug
may need to be cleaned or replaced with a new spark plug before engine
will start.
Fuel type change: Generators are shipped ready to operate on JP-8 or F-
24. Switching fuel type, from JP-8 to gasoline for example, requires
careful attention. Please refer to P. 12-14 for instructions on switching
fuels.
*applies to generators equipped with Eco-mode
3
To Next Page
Loading...