Novation Impulse 49 - Using Impulse with DAW; DAW Control Overview

11
Using Impulse with your
DAW
After installation and successful HUI setup, start your DAW (Digital Audio Workstation). You will see on the
Impulse that the fader/s are in mixer mode and the encoders are in plug-in mode. At this point it would be
good to create a new song with at least eight audio tracks.
Open the mixer view in your DAW
• Move the fader/s on the Impulse - you should see the track volumes moving on screen
• Move the encoder/s on the Impulse - you should see the track pan moving on screen
For further information see the User Guide for Impulse available from the novationmusic.com/
impulsedownloads.