6
CLEANING THE APPLIANCE
• Rinse with clean water. Remove stubborn contamination with a brush
and detergent.
• Submerge the pump in a container with clean water and switch on for a short
time to rinse the inside of the pump.
CLEANING THE SUCTION AREA
Clean all accessible parts of the casing. Remove bres which have wound around
the rotor shaft by opening the pressure connection. Remove stubborn
contamination with a brush and detergent.
Note: Before using the pump again, rinse it so that any possible
dirt residue do not block the appliance.
STORING
If there is a risk of frost, dismantle the appliance and accessories, clean them and
store in a place protected from frost.
Attention !
Riskofdamagetotheappliance!
Frost destroys the appliance and accessories, as these always
contain water.
DISPOSAL
Products which are labeled with the symbol shown must not be
disposed of in household rubbish. You must dispose of such old
electrical and electronic equipment separately. Please check with
your local authority about disposal.
To prevent damaging materials to get in the environment, send old equipment
for recycling or other forms of re-use.
The packaging consists of cardboard and plastics that can be recycled.
Danger !
Danger of severe physical injuries
Repairs that are improperly performed may prevent your appliance
from working safely. Such repairs will endanger you and your
surroundings.
To Next Page