NOVO NVO465-100 User Manual

NovoSoft 465 Series
Water Softener Operation Manual
Note:
1. Read all instructions carefully before operation.
2. Avoid pinched o-rings during installation by applying (provided with install kit) NSF certified lubricant to all seals.
3. Unit is factory set for “Clean Water” application. See factory settings for “Problem Water” on page 10.
4. This system is not intended for treating water that is microbiologically unsafe or of unknown quality without adequate disinfection before or
after the system.
Rev 1, May 28, 2012
Tested and Certified by the Water Quality
Association to CSA B483.1.
Canadian Head Office
655 Park St.
Regina, SK S4N 5N1
Eastern Sales & Distribution
20 Steckle Place, Unit 21
Kitchener ON N2E 2C3

NOVO NVO465-100 Specifications

General

Brand	NOVO
Model	NVO465-100
Category	Water Dispenser
Language	English

Summary

System Specifications

How Your Water Conditioner Works

Main Valve Functions

Regeneration Mode

Defines how and when regenerations are initiated.

Capacity Calculation

Settings for automatic or manual capacity calculation.

Adjustable Cycles

Lists the adjustable cycles within the regeneration process.

Manual Regeneration

Details how to initiate manual regeneration cycles.

General Installation

Control Operation During A Power Failure

Start-Up Instructions

Level I User Programming

Setting Current Time

Instructions for setting the current time on the controller.

Setting Current Date

Instructions for setting the current date on the controller.

Setting Number of People

How to set the number of people for daily usage calculation.

Setting Water Hardness

How to set the water hardness level in grains per gallon.

Setting Vacation Mode

Instructions for enabling and configuring vacation mode.

Level II User Programming

System Language

Controls the display language of the valve.

Valve Operation

Selects the operating mode (Softener, Filter, Iron Filter).

Regen. Mode

Defines how and when regenerations are initiated.

Capacity Calc.

Settings for automatic or manual capacity calculation.

Regeneration Time

Sets the daily time for regeneration cycles.

Restore Default

Resets all settings to factory defaults.

Diagnostics Mode

Vacation Settings Mode

System Configuration

Valve Set Up

Table of default valve cycle settings for different models.

Changing Valve Cycle Settings

Steps to modify the default valve cycle parameters.

Automatic Bypass

Explains the bypass function during regeneration.

Maintenance

Manual Bypass

How to use the manual bypass valve in emergencies.

Adding Salt

Instructions for checking and adding salt to the brine tank.

Bridging

Explains salt bridging and how to resolve it.

Care of Your Softener

Recommendations for cleaning and protecting the softener's appearance.

Cleaning the Injector Assembly

Resin Cleaner

Sanitizing Procedure

Valve Drive Assembly Exploded View

Control Valve Assembly Exploded View

Trouble Shooting

Regeneration Failures

Addresses issues like unit failing to initiate regeneration.

Water Quality Problems

Covers hard water, low pressure, resin in drain, and brine draw issues.

Salt and Brine Tank Issues

Deals with high salt usage and excess water in the brine tank.

Valve Operation and Flow Issues

Solves continuous valve cycling and drain flow problems.

NovoSoft Guarantee

Seven Year Complete Parts Guarantee

Details the warranty coverage for parts.

Life Time Year Guarantee on Mineral Tanks and Brine Tanks

Covers warranty for mineral and brine tanks.

General Provisions

General terms and limitations of the guarantee.