NQ Industries Clarifier - Maintaining Your NQ Clarifier; Cleaning and Changing Filters; How to Clean Your Pre-Filter

4
GREEN INDICATOR LIGHT-
Remains on when the UV light is operating properly.
When the light goes out the UV lamps are not functioning.
RED INDICATOR LIGHT
Order new lamps from your supplier and go to the “Change UV Lamps Section”
-
Goes on when it’s time to change or clean pre-filter or change HEPA filter.
Go to the “Clean Prefilter Section” on page 4,5.
Maintaining Your NQ Clarifie
CLEANING AND CHANGING FILTERS
r
*****SAFETY WARNINGS
 BEFORE YOU ATTEMPT ANY
MAINTENANCE
*****
ALWAYS UNPLUG THE
UNIT

.
NEVER LOOK DIRECTLY AT THE ULTRAVIOLET LAMPS WHEN LIT.
HOW TO CLEAN YOUR PRE-FILTER
THE LIFE OF THE CARBON PRE-FILTER
The pre-filter can be vacuumed numerous times to increase the service life of the filter.
The pre-filter can last approximately 1 to 2 years depending on the amount of dirt in the air
and the amount of use. If the red light does not go off after cleaning the pre-filter, then the
pre-filter must be changed.
TOOLS REQUIRED: A Phillips screwdriver
WHEN THE RED INDICATOR LIGHT GOES ON
IMPORTANT
Before opening the unit to change the pre-filter,
:
Vacuum the outside of the unit at the bottom vents.
If the Red Indicator Light does not shut off
Then it is necessary to open the unit and clean the pre-filters.