13
S
T A
Y
REPLACEMENTS
SPARE PARTS
SUSPENSION SETTINGS
ACCESSORIES:
- ChainStay Slapper protector 2 pc. (SP-208)
- seatpost clamp 34.9 (SP-144)
Suspension settings are a matter of personal preference. Some riders like it plush, some like it
firm. However here are some suggestions of shock settings that you can use as basic guidelines.
Typically, the E-fine should run with about 20% to 30% sag. To measure sag, push the bottom-out
bumper up the shock shaft until it meets the body of the shock. Gently stand up on the pedals
with all your weight on the bike (fully kitted up with body armour, helmet, neck brace, hydration
pack, etc. – it’s important to make the situation as ‘real world’ as possible to give you the most
accurate results) and note how far the bumper displaces
REAR WHEEL MOUNTING INSTRUCTION
The Efine frame is compatible with 148x12 thru-axle hubs. For proper rear wheel installation please
follow the instructions:
- make sure the wheel is aligned and the disc sits properly in the brake caliper
- put the wheel into the dropouts with the chain set up correctly on a cassette
- put the 12mm axle through and tighten properly with 6mm allen key
FRAME SIZE RECOMMENDATIONS
note on sizing: we recommend the S size for 160 - 170cm, M size for 170 – 182cm and the L size for
riders over 180cm.
To Next Page
