NSK ASTRO-E 400Z - 10．Motor Cord Connection; 11．Air Hose Connection

10
・                   ④
     ⑥           !
  
・     !          
      ! ! ②    ""   
#            
・ $                  
        !        
   
！
%&
・Align the guide pin A on the motor plug with the key way B on the motor socket on the right side of
the control unit.
・Screw in the coupling nut C of the motor plug to the motor socket D on the side of the control
unitNoise Reduction Coil
"'
10  (  
Ｂ
Ａ
NoiseReductionCoil
Ｄ
Ｃ
11   ) 
・Insert the 4㎜ motor cooling air hose with φ6-φ4 adaptor into the inlet joint ④ on the right side of
the control unit.
・InserttheprovidedairhosewithfilterfromAL-0201intotheinletjoint⑥.
(IfyouarenotusingtheAL-0201airlinekitmakesurethattheincomingairsupplyisdry,clean
air.)
・Regulateairpressurebetween0.2-0.5MPa.Iftheselectorunit(NE62)isused,insertthe(6㎜
coolingairhoseintotheoutputjoint④.
・Regulateairpressureat0.5MPa.
"*
④CoolingAirOutputJoint
Reducer(φ6-φ4 Adaptor)
⑥AirInputJoint
AirHosewithFilter