Reversible vibratory plates Operating instructions
side 20 edition 06/2009
3. Put the choke into the ON position (1). Do not use the choke if the engine is hot or at higher
ambient temperatures.
When operating the HONDA Engines, follow the Honda operating instructions.
4. Put the control lever in the idle-run position (1).
5. Pull the handle of the starting wire a little until you feel a resistance. Then pull the wire swiftly.
Do not release the handle quickly but hold it by hand on its reverse movement.
6. After the engine heats up put the choke lever into the OPEN position.
7. Let the engine heat up sufficiently before work.
8. Put the throttle lever to the full throttle position (1). At approximately 1,700 r.p.m., the
centrifugal clutch is automatically activated and the machine starts to vibrate.
To Next Page
Loading...
