To Next PageTo Next Page
Need help?Do you have a question about the NTI Trin & Stor S50 and is the answer not in the manual?
General| Brand | NTI |
|---|---|
| Model | Trin & Stor S50 |
| Category | Water Heater |
| Language | English |
Details the specifications for the Trin & Stor series, including tank types and performance metrics.
Information on certifications and approvals for solar models, meeting US and Canadian standards.
Details checklists for installation, operation, and maintenance (IOM) to ensure proper installation.
Outlines the user's role in proper installation, maintenance, and use of the appliance.
Defines the installer's responsibility for safe installation according to codes and manual guidelines.
Discusses the risk of Legionella bacteria growth and its health implications.
Explains the risk of scald injury from hot water and basic precautions to prevent burns.
Recommends thermostatic mixing valves to temper water and reduce scald hazard potential.
Provides general guidelines for maintaining and operating potable water systems, including temperature settings.
Details domestic side piping connections, dimensions, and installation for Trin & Stor indirect water heaters.
Instructions on flushing the system and checking water composition before connecting plumbing.
Lists and describes major components required for a properly installed indirect water heater system.
Details critical components such as T&P relief valve, tank sensor, drain valve, backflow preventor, expansion tank, and mixing valve.
Describes plumbing the solar water heater in series with an auxiliary water heater for pre-heating.
Explains using the solar water heater as a primary tank with auxiliary boiler backup.
Details using the solar water heater as a primary tank with an additional storage tank.
Step-by-step guide to locating the thermal well, inserting, and securing the tank sensor.
Details specific settings for DHW configuration, demand switch, setpoint, and temperature for Tft & Lx boilers.
Instructions for setting DHW mode and setpoint on Trinity Tx Series boilers when using a Tank Sensor.
Step-by-step guide to filling the water heater and checking for leaks before operation.
A checklist to verify electrical connections, sensor installation, and boiler operation for DHW demand.
Covers visual inspections, maintenance checks, relief valve operation, and water chemistry testing.
Details draining the water heater and reinstalling the heat exchanger for the SL Series.
