To Next PageTo Next Page
Need help?Do you have a question about the NuAire LabGard ES NU-543-400S and is the answer not in the manual?
General| Filter Type | HEPA |
|---|---|
| Filter Efficiency | 99.99% at 0.3 microns |
| UV Light | Optional |
| Type | Class II, Type A2 Biological Safety Cabinet |
| Width | 48 inches |
| Work Surface Height | 30 inches |
| Inflow Velocity | 105 fpm |
| Airflow | Variable |
| Lighting | LED |
| Electrical Requirements | 115V, 60Hz |
| Motor | ECM |
| Certifications | NSF/ANSI 49 |
| Exhaust Airflow | Variable |
| Recirculated Airflow | Variable |
Details how to set up the Biosafety Cabinet, including base stand and bench installation.
Information on electrical connections and power requirements for the cabinet.
Details the features and functions of the FlowGard™ electronic control system.
Describes the functions of the control system's front panel keys and LEDs.
Details the operation of the cabinet during its active run mode, including warm-up.
Describes audible and visual alarms during standby and run modes.
Guidance on preventing air curtain disruption for containment.
Explains the importance of unidirectional airflow for contamination control.
Steps to start the cabinet and prepare for operation.
Steps and recommendations for performing work within the cabinet.
Procedures and safety precautions for cabinet decontamination.
Step-by-step guide for manual decontamination of the cabinet.
Details automated decontamination processes using specific equipment.
Procedure to configure cabinet blower for automated decontamination cycles.
Step-by-step guide for HEPA filter and motor/blower replacement.
Establishes nominal airflow velocity and alarm limit setpoints.
Procedure for calibrating the downflow air velocity.
Procedure for calibrating the inflow air velocity.
Adjusts airflow sensor values for accurate readings.
Procedure for testing the supply HEPA filter.
Procedure for testing the exhaust HEPA filter.
Lists error messages and their corresponding troubleshooting steps.
