Exhaust temperature too high
protection
EEPROM error indication (indoor
main control board) / EEPROM error
indication (wired controller)
Evaporator coil temperature too
high protection
Heating supply return water
temperature too high protection or
cooling water temperature too low
protection,
System high pressure switch
disconnected protection
DC bus voltage is too high / too low
protection
Communication failure between
wired controller and indoor unit
main board
IPM (module board) fault protection
communication failure between
Outdoor board and IPM (module
board)
DC fan stall failure protection
System low pressure switch
disconnected protection
Temperature difference between
inlet &outlet water too large
protection
Return gas temperature sensor
failure
Return water temperature sensor
failure
Refrigeration tube temperature
sensor failure
Outlet water temperature sensor
failure
Antifreeze switch
disconnectedfailure
Water tank temperature sensor
failure
Enhanced Vapor temperature
sensor failure
Outdoor ambient temperature
sensor failure
Evaporator coil temperature sensor
failure