Numark MIXTRACK PLATINUM FX - Page 9

33.
Fader Cuts (Pad):
With this Pad mode, the top 4 performance pads
are used to perform transform effects for cuts on
scratching.
*See Performance Pad Modes Section Section
SHIFT: Each pad triggers an roll of
a different length
34.
Sampler (Pad):
With this Pad mode, each pad triggers a sample in
the software.
*See Performance Pad Modes Section
SHIFT: Selects layer 2 of samples
- Performance pads then trigger
samples 9-16.
35.
Performance Pads
The pads are used to trigger loop points or samples depending on the Pad mode setting.
*See Performance Pad Modes Section
36.
Loop On/Off:
Press to activate auto loop on/off. Hold Shift and
press this button to trigger a re-loop.
Re-Loop
Triggers a re-loop
37.
Loop 1/2:
Press this button when a loop is active to decrease
the loop size by half.
Loop In (Manual Loop)
Set the Loop In point for a manual
loop.
38.
Loop x2:
Press this button when a loop is active to double
the loop size.
Loop Out (Manual Loop)
Set the Loop Out point for a
manual loop.