Numark Mixtrack Pro 3 User Manual

3
User Guide (English)
Introduction
Box Contents
MIXTRACK PRO 3
USB Cable
Software Download Card
User Guide
Safety & Warranty Manual
Support
For the latest information about this product (system requirements, compatibility information, etc.)
and product registration, visit numark.com.
For additional product support, visit numark.com/support.
Quick Start / Connection Diagram
1. Place MIXTRACK PRO 3 on a flat, stable surface.
2. Make sure all devices are turned off and all faders and gain knobs are set to “zero”.
3. If using a microphone, connect it to MIXTRACK PRO 3’s mic input.
4. Connect MIXTRACK PRO 3’s outputs to power amplifiers, tape decks, and/or other audio
sources.
5. Plug all devices into AC power and connect MIXTRACK PRO 3’s USB port to a computer’s
USB port using the included USB cable.
6. When powering everything on, power on your devices in the following order:
• Your computer
• Any amplifiers, speakers, or output devices
7. Locate the Serato DJ Intro installation card in the box to download and install the software.
8. Open your software program and load music to the decks.
9. Start DJ’ing!
10. When powering everything off, power off your devices in the following order:
• Any amplifiers, speakers, or output devices
• Your computer
MICROPHONE*
SPEAKERS*
COMPUTER*
HEADPHONES*
* not included

Numark Mixtrack Pro 3 Specifications

General

Platter size	5 \
Mixer section	Yes
Product color	Black
Number of drum pads	16
Built-in optical drive	-
Number of scratcher platters	2
Microphone connectivity	6.3 mm

Weight and Dimensions

Depth	550 mm
Width	232 mm
Height	30 mm
Weight	1900 g