Attach the hanging bars (12) to the arms by sliding the bottom hole in the bars over the
pins on the outside of the arms. Position the bars so that the end labeled “TOP” is up
and facing toward the swing seat. At each end of the seat assembly, bring together
the holes in the top ends of the hanging bars and thread them on to an “S” hook (N).
Hang the “S” hooks and seat and back from the loops on the short top crossbar.
Insert a large canopy frame bar (14) into the large canopy frame (13) as per drawing.Place
the large canopy (19) over the assembled canopy frame (13 & 14) spread to the
location as per drawing.
To Next Page
Loading...