6
(H)
(L)
(M)
(J)
(11)
(H) x 2
(J) x 2
7
Assembly instruction
8
(10)
(11)
(L) x 2
(M) x 2
Unfold the seat and back (11) and lay it on top of the frame. Line up the holes in the
arms (7 & 8) with the holes in the side tubes of the seat and back (11). Insert an bolt (H)
(from outside to inside) through the bracket of the arm, through a plastic washer (M),
through the side bar on the seat and back, through an metal washer (L) and an nut (J).
Do not tighten completely. Repeat procedure for the other side. Then securely tighten
the bolts and nuts.
Raise the back side of the seat and back (11) and fasten the U-shaped bracket of the
back support tube to the rear seat support bar (10) as per the drawing.
To Next Page
Loading...