Numark MONTEREY 3-SEAT SWING/DAYBED - Step 5: Securing Rear Leg Crossbar; Step 6: Assembling Seat Support Bars

5
(D) x 2
(K) x 2
5
(10)
(7)
(10)
(9)
FRONT
(7)
(8)
Assembly instruction
6
(6)
(3)
(D)
(K)
Place the rear leg crossbar (6) between the side panel (3), line up the holes, insert an
bolt (D) through an metal washer (K), through the side panel (3), and secure into the
rear leg crossbar (6). Do not tighten completely. Repeat procedure for the other side.
Tighten all bolts in the whole frame.
Lay out the right arm (7), left arm (8), front seat support bar (9) and rear seat support
bar (10). Make sure that the labels marked “Front’’ on the arms and seat support bars
are all facing the front edge of the seat. Attach the seat support bars to the arms by
pressing the tabs on the ends of the seat support bars down into the brackets on the arms.
Make sure they are securely seated.