Numark NS6 - Connection Diagram; Power and USB Cable Setup

DISASSEMBLY PROCEDURES
3. REMOVAL OF CROSS FADER ASSEMBLY AND KNOB. (Fig3)
(A) TAKE OUT THE 1 PC KNOB FROM THE PANEL.
(B) TAKE OUT THE 2 PCS SCREWS AND 1 PC CONNECTORS FROM THE PANEL.
(C) TAKE OUT THE ALL KNOB.
Fig.3
4. REMOVAL OF MIXER PCB AND LEFT PCB.(Fig4)
(A) TAKE OUT THE 23 PCS SCREWS AND 6 PCS CONNECTORS FROM THE MIXER PCB.
(B) TAKE OUT THE 16 PCS SCREWS AND 3 PCS CONNECTORS FROM THE LEFT PCB
Fig.4