Need help?Do you have a question about the Numark NDX500 and is the answer not in the manual?
General| Frequency range | 20 - 20000 Hz |
|---|---|
| Audio formats supported | MP3 |
| Signal-to-Noise Ratio (SNR) | 80 dB |
| Total Harmonic Distortion (THD) | 0.03 % |
| CD-R playback | Yes |
| CD changer | No |
| Device type | - |
| Product color | Black |
| Playback disc types | CD, CD-R, CD-RW |
| Supported file systems | FAT16, FAT32 |
| Cables included | AC, RCA, USB |
| Power source type | AC |
| AC adapter frequency | 50 / 60 Hz |
| AC adapter input voltage | 115 / 230 V |
| Power consumption (typical) | 20 W |
| USB 2.0 ports quantity | 1 |
Weight and Dimensions| Depth | 292 mm |
|---|---|
| Width | 216 mm |
| Height | 106 mm |
| Weight | 3200 g |
Connect NDX500 via USB to computer and mixer via RCA. Connect amplifier to mixer output. Power on devices. Set NDX500 to MIDI mode.
NDX500 is class-compliant; no drivers needed. Check Numark for firmware updates.
Download, install, and log in to VirtualDJ 8 using your virtualdj.com account.
Launch VirtualDJ 8. Confirm device detection and configure audio settings by clicking "Use Soundcard" and "OK".
Configure the unit in VirtualDJ's Controller tab using factory default mapping or custom VDJ Script.
Utilize the pre-defined audio setup and special button within VirtualDJ's AUDIO tab for configuration.
SOURCE cycles modes (CD/USB/MIDI). SHIFT accesses secondary functions. EJECT selects MIDI channels.
PLAY/CUE/TAP for playback/cueing. TRACK encoder/FOLDER button for browsing and track selection.
LCD screen info. TIME cycles display modes. SINGLE toggles Automix. PROG cycles text modes. LOOP IN/OUT set loop points.
RELOOP exits/triggers loops. REC deletes HotCues. HOTCUE buttons assign/return points.
JOG wheel for scratch/pitch bend. MASTER TEMPO locks key. PITCH RANGE/FADER/BEND adjust tempo.
Links to VirtualDJ website, support center, and operation guides.
Links to Numark website, support center, product page, and user guide.
To Next Page
