8
8
COMPONENT INTERVAL INSPECT FOR
Mains Lead DAILY
Pads/Brushes BEFORE EACH USE Damage, wear, drive collar wear
Handle and Deck BEFORE EACH USE Wear, cracks, splits
routine and preventative maintenance is carried out periodically in order to ensure its safe operation. Operators shall be
adequately instructed as to the correct use of the machine.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard
could render this equipment unsafe and the manufacturer can accept no responsibility or liability in this respect.
stops. Avoid sharp turns. Use low speed down ramps. Clean only while descending (driving down) the ramp.
This machine is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations.
When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the operator and
Wear nonslip footwear when scrubbing. Use a respiratory mask in dusty environments.
Mains operated machines shall be disconnected by removing the power plug, and battery operated machines shall be disconnected by
using top ON/OFF button on the battery.
Machines left unattended shall be secured against unintentional movement.
When detergents or other liquids are used, read the manufacturer’s instructions.
Do not allow the supply cord to come into contact with the rotating brushes or pads.
This machine is not suitable for picking up hazardous dust
This machine shall be stored indoors only
This machine is for indoor use only.
NOTES: This machine is intended for commercial use, for example in hotels, schools, hospitals, factories, shops, offi ces
and rental businesses. This Product meets the requirements of IEC 60335 - 2-67
• Ensure only competent persons unpack/assemble the machine.
•
•
• Replace any worn or damaged parts immediately.
•
• Only replace the power cord with the correct Numatic approved replacement parts.
• Ensure that the work area is clear of obstructions and / or people.
• Ensure that the working area is well illuminated.
•
• Use steam cleaners or pressure washers to clean the machine or use in the rain.
• Attempt machine maintenance or cleaning unless the power plug has been removed from the supply outlet.
•
• Strain cable or try to unplug by pulling on cable.
• Leave the brush pad on the machine when not in use.
•
•
• Run the machine over power cable during operation.
• Lift or pull the machine by any of the operating triggers, use the main handle.
•
WARNING
CAUTION
DO
DON’T
Information for Floor Machine
READ MANUAL BEFORE USE
EN
To Next Page
Loading...
