How to fix no brush / scrub function on Numatic Floor Machine?
If your Numatic Floor Machine has no brush or scrub function, make sure that the brushes are correctly fitted. Also, ensure that the brush deck is lowered.
Why is my Numatic Floor Machine not picking up water properly?
If your Numatic Floor Machine isn't picking up water well, several factors could be the cause. First, check if the waste-water tank is full and empty it. A blocked vacuum hose can also cause this issue; remove and clean it. Ensure hose connections are tight by pushing them firmly. Additionally, inspect the debris basket filter and separator filter for clogs or blockages and clean them if necessary. A poor separator seal can also be the culprit; clean and refit it. If the separator seal, vacuum hose, or floor-tool blades are damaged, they may need to be renewed. Contact the service department for assistance with replacements.
What to do if my Numatic Floor Machine has little or no water flow?
If your Numatic Floor Machine has little to no water flow, the clean-water tank might be empty; fill it. Another possible cause is a blocked or clogged clean-water tank filter; remove and clean it. Also, ensure the brush deck is lowered.
Covers essential warnings, cautions, and operational do's and don'ts for safe use.
Instructions on how to adjust the machine's handle position for operation.
Guidance on correctly attaching the top tank to the machine.
Steps for securely installing the brush or pad onto the machine.
Procedure for moving the brush deck between transit and operating positions.
Instructions for attaching and securing the floor tool assembly.
Instructions on how to select and use the machine's operating controls.
General| Voltage | 230 V |
|---|---|
| Brush Speed | 150 rpm |
| Working Width | 450 mm |
| Brush Size | 450 mm |
| Pad Size | 450mm |
| Solution Tank | 40 L |
| Recovery Tank | 40 L |
| Cleaning Width | 450 mm |
To Next Page