Need help?Do you have a question about the Numatic TTB-455 and is the answer not in the manual?
General| Model | TTB-455 |
|---|---|
| Category | Floor Machine |
| Voltage | 24 V |
| Cleaning Width | 450 mm |
| Weight | 45 kg |
| Tank Capacity | 40 L |
| Brush Motor Power | 400 W |
| Frequency | 50 Hz |
| Brush Size | 450 mm |
| Solution Tank | 40 L |
| Recovery Tank | 40 L |
| Type | Scrubber Dryer |
Identifies all major components of the TTB-455 scrubber dryer, including tanks, brush deck, and controls.
Step-by-step guide for basic machine operation, including starting, cleaning, and stopping procedures.
Essential guidelines for safe and effective use, covering operational practices and user conduct.
Explains the function of buttons and indicators on the machine's control handle for water and vacuum operations.
Details how to adjust the handle for optimal ergonomics and control during operation, affecting floor pressure.
Describes the mechanism for controlling water flow to the brush, including tap operation and flow rates.
Instructions on how to properly fill the clean water tank with water and detergent for operation.
Step-by-step guide for attaching brushes or drive boards to the machine's gearbox.
Addresses common operational issues like poor water pickup or short run times and provides diagnostic checks.
Instructions on how to remove worn squeegee blades and install new ones for effective water pickup.
Procedure for connecting the machine to a power source to charge its batteries, including charge time.
Recommended daily cleaning tasks for brushes, squeegee, and tanks to ensure machine longevity.
Guide on how to locate, remove, rinse, and replace filters for both the bottom and top tanks.
Instructions for cleaning the separator filter located within the machine's system.
Steps for safely draining water from both the bottom and top tanks into a drain.
To Next Page