Why is there no brush or scrub function on my Numatic Floor Machine?
If your Numatic Floor Machine has no brush or scrub function, first check if the brushes are properly fitted. If not, fit them correctly. Also, the brush may be overloaded, in that case reset the machine.
What to do if my Numatic TTB 4055/100 Floor Machine has poor water pick-up?
If you're experiencing poor water pick-up with your Numatic Floor Machine, several issues could be the cause: * The waste-water tank might be full, in which case you should empty it. * The vacuum hose, debris basket filter, or separator filter could be clogged or blocked, requiring removal and cleaning. * Hose connections might be loose, so ensure they are pushed tight. * The separator seal might be faulty, try cleaning and refitting it. Note that damaged separator seals, vacuum hoses, or floor-tool blades require contacting the service department for renewal. * Also, check if the battery charge is low and recharge the batteries if needed.
Why is there little or no water flow in my Numatic TTB 4055/100 Floor Machine?
If you're experiencing little to no water flow in your Numatic Floor Machine, consider the following possible causes: * The clean-water tank might be empty, so fill it. * The clean-water tank filter might be blocked or clogged, so remove and clean it. * The clean-water tap might not be turned on, so ensure it is turned on.
How to troubleshoot no brush / scrub function on Numatic TTB 4055/100 Floor Machine?
If the brush/scrub function isn't working on your Numatic Floor Machine: * Check if brushes are fitted; if not, fit them. * The brush might be overloaded; if so, reset the machine.
What to do if my Numatic Floor Machine just stops while operating?
If your Numatic Floor Machine stops during operation, it might be due to too much load on the brush system. Try resetting the machine and decreasing the brush load to better suit the floor type. Also, check the battery pack for a blown fuse and replace the 50 Amp fuse if necessary.
Why is my Numatic TTB 4055/100 not picking up water well?
If your Numatic Floor Machine isn't picking up water effectively, it could be due to several reasons. First, check if the waste-water tank is full and empty it if needed. Also, inspect the vacuum hose, debris basket filter, and separator filter for any clogs or blockages and clean them. Ensure that all hose connections are tight and the separator seal is properly fitted and clean. If the separator seal, vacuum hose, or floor-tool blades are damaged, consider contacting the service department for replacements. Finally, make sure the batteries are fully charged.
How to troubleshoot a Numatic Floor Machine that will not operate?
If your Numatic Floor Machine isn't operating, start by checking the fuses. Replace any missing or blown fuses. Next, ensure the battery is properly connected. Finally, check the battery charge level and charge the batteries if they are low.
What to do if my Numatic TTB 4055/100 has little or no water flow?
If your Numatic Floor Machine has little or no water flow, ensure the clean-water tank is full. Also, check the clean-water tank filter for any blockages and clean it if necessary. Finally, make sure the clean water tap is turned on.
What to do if the vacuum will not operate on my Numatic TTB 4055/100 Floor Machine?
If the vacuum on your Numatic Floor Machine isn't operating, turn on the vacuum.
Why Numatic Floor Machine will not operate?
If your Numatic Floor Machine isn't operating, check the following: * Missing or blown fuses: Fit or replace the fuse. * Battery connection: Ensure the battery is properly connected. * Battery charge: Charge the batteries if the charge is low.
General| Brand | Numatic |
|---|---|
| Model | TTB 4055/100 |
| Category | Floor Machine |
| Language | English |
To Next Page