9
The water level in the clean water tank can be seen using the clean-water clear
dump hose tted to the rear of the machine.
The clean water bottom tank holds 40 litres.
Machine Set-Up
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specication.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit http://www.hse.gov.uk/ for UK information.
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
!
!
WHEN HANDLING AND MIXING CHEMICALS.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
! !
Note.
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the
clean-water during the lling process.
If using a bucket or similar, ensure it is always clean and free from debris.
Clean water level
The TT / ET Range are all equipped with a 40 litre clean-water tank allowing large areas to be cleaning in a single ll.
Filling the clean-water tank
To ll the clean-water tank, use the 1 meter FLEXI
- FILL pipe from either a tap or hose pipe (Fig 12).
The large cap can also be unscrewed for lling
from a bucket or suitable
container.
Fill the clean water tank to a maximum of 40 litres,
including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
The clear Dump hose at the rear of the machine can be used to see the level of the clean water.
Fig 12
Turn on the clean water tap
On
Off
Clean water tap
To Next Page
Loading...
Need help?
General
