Product Use
Head and Body Support
The head and body supports can be used as
necessary, to provide a snug fit for small babies.
The head support straps cannot go through the
same slots as the harness and should only be
used in the top two harness slot positions.
1 - Insert the head support straps through the
harness slots.
2 - Then fasten the hook and loop ends behind the
seat fabric.
3 - To insert the body support, unbuckle the
harness and route the buckle and crotch belt
through the bottom slot of the body support.
4 - The low birth weight pillow (located on the
back of the body support) can be used in
the body support for even smaller babies,
but MUST be removed once a snug fit can
be achieved without it. The pillow MUST be
removed when the child reaches 11 lb.
5 - To remove the low birth weight pillow, unfasten
the hook and loop on the back of the body
support and pull out the pillow.
6 - Harness straps must be at or just below
child’s shoulders to avoid injury. If harness
slots need to be moved refer to the instructions
in the PIPA or PIPA lite series instruction
manuals.
1
2
3
4
5
6
9
PIPA series organic cotton insert instructions8 PIPA series organic cotton insert instructions
To Next Page
Loading...
