1817
PRYM instructions PRYM instructions
EN
EN
4 - Fix the buckles on the both sides of the seat
which located on the both sides of seat to make
placing the child in rearward facing mode more
convenient. (29)
5 - Please make sure the infant insert has the wedge
assembled before using it for infant. (30)
6 - Place the child into the enhanced child restraint
and lock the buckle. Please refer to (31).
7 - Tighten the shoulder harness straps by pulling the
adjustment webbing. (32)
Make sure the space between the child and the
shoulder harness straps is about the thickness of
one hand.
The cushion can
be used separately
without being
attached to the
insert to bolster the
infant’s back for
more comfort.
We recommend
using the full infant
insert while the baby
is under 60 cm or
until they outgrow
the insert. The infant
insert increases side
impact protection.
Detach the snaps
on the head support
to remove the head
portion of the insert.
Remove the head
support portion of
the infant insert
when the child’s
head no longer fits
comfortably.
Remove the body
portion of the infant
insert when the
infant’s shoulders no
longer fit comfortably.
Remove the infant
insert cushion by
detaching the snaps
to allow more space
when the infant does
not fit comfortably.
Baby Mode (Rearward Facing Mode)
Rearward Facing
Child height 40cm-105cm/ Child weight≤18kg
Recline position
Position 1-7
1 - Please slide Smart Ride™ lock-off to right when
enhanced child restraint used in rearward facing
mode. (22)
2 - Press the rotating button to rotate the seat to the
rearward facing position. (23)(24)
The ISOFIX connectors must be attached and
locked onto the ISOFIX anchor points. (24)-1
The load leg must be installed correctly with
green indicator. (24)-2
Securing Child
After the child is placed into the seat, check whether
the shoulder harness straps are at proper height.
1 - Press the rotating button to rotate for easier side
loading/unloading of the child. (25)(26)
2 - Press the harness adjustment button, while
pulling out the shoulder harnesses to the desired
(Pull from below the fixed shoulder pads to
lengthen) length. (27)
3 - Unlock the buckle of the harnesses by pressing
the red button. (28)
To Next Page
Loading...
Need help?
General
