Nuna rava - Page 2

1
EN
Cleaning and Maintenance
WARNING: Do not attempt to disassemble
the Child Restraint. Only perform steps shown in
this manual.
Seat Cover Removal
1 To remove seat pad: (1)
a Recline Child Restraint to
rear facing position 1 (BLUE).
b Set Head Support in
highest position.
c Loosen and unbuckle
Harness and Chest Clip.
d Fully extend Calf Support.
e Remove Tether from Storage Anchor.
2 Remove Harness/Buckle Pads as well as Infant
and Head Inserts.
Take care when removing Head Support Cover
so as not to damage the energy absorbing foam.
3 Remove Head Support Cover.
(2)
a Grasp Head Support
Cover at top behind Head
Support Button.
b Peel Cover off Head
Support; work on one side
then the other. Unsnap
Cover and remove.
1
e
a
b
c
d
2
a
b