Page 43 of 54
DISCONNECT THE AIR SUPPLY TO PREVENT THE QUICKSPAN TO UNCLAMP UNEXPECTLY
Which may result in an internal damage
Attach the adapter to the balancing unit
Pre centre the adapter using the delivered tapered
screws
Replace the tapered screws with the „original“ helical
screws and tighten them crosswise
After having tightened all 4 „original“ helical screws put the motorcycle adaptor or the
universal adaptor on the cone and tighten it with the screw (Shaft of the motorcycle adaptor /
16mm screw on universal adaptor)
Perform a zero run
(refer to instruction manual for more information)
To Next Page
Loading...