EasyManua.ls Logo

NuTone 765HFL User Manual

NuTone 765HFL
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Page 1
MODEL 765HFL
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address
or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel. Lock or tag service panel to prevent power from being
switched on accidentally.
3. Installation work and electrical wiring (including switch location)
must be done by a qualied person(s) in accordance with all
applicable codes and standards.
4. Provide sufcient air for proper combustion and exhausting of
gases through the ue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the combustion equipment
standards such as those published by the National Fire Pro-
tection Association (NFPA), the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE), and
local codes.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Provide a separate 20 AMP circuit. Use 12 GA., 90
o
C minimum
power cable which meets code.
8. Do not use a speed control with this product.
9. This unit must be grounded.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazard-
ous or explosive materials and vapors.
2. THIS PRODUCT MUST BE MOUNTED IN A FLAT CEILING
ONLY. Installations in ceilings 9-feet high or less will provide
maximum comfort. DO NOT MOUNT THIS PRODUCT IN A
WALL.
3. Install in ceiling only - at least 6 inches from any wall.
4. To avoid motor bearing damage and noisy, unbalanced impel-
lers, keep drywall spray, construction dust, etc. off motor and
impeller.
5. Read specication label on product for information and require-
ments.
VENTILATION FAN
WITH HEATER & FLUORESCENT LIGHT
READ AND SAVE THESE INSTRUCTIONS
CLEANING & MAINTENANCE
WARRANTY
Installer: Leave this manual with
the homeowner.
For quiet and efcient operation, long life, and attractive appear-
ance - lower or remove grille and vacuum interior of fan with a
dusting brush attachment.
The motor is permanently lubricated and never needs oiling. If
the motor bearings make excessive or unusual noise, replace
the motor with the exact service motor. The impeller should also
be replaced.
Replace light bulb with a 27-Watt, 3500K (maximum) GU24
uorescent lamp.
OPERATION
Use a 3-Function Control to operate the heater, fan, and light
separately. See “Connect Wiring” for details.
BROAN-NUTONE ONE YEAR LIMITED WARRANTY
Broan-NuTone warrants to the original consumer purchaser of its products that such products
will be free from defects in materials or workmanship for a period of one year from the date
of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE.
During this one-year period, Broan-NuTone will, at its option, repair or replace, without
charge, any product or part which is found to be defective under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND
TUBES. This warranty does not cover (a) normal maintenance and service or (b) any
products or parts which have been subject to misuse, negligence, accident, improper
maintenance or repair (other than by Broan-NuTone), faulty installation or installation
contrary to recommended installation instructions.
The duration of an implied warranty is limited to the one-year period as specified for the
express warranty. Some states do not allow limitation on how long an implied warranty
lasts, so the above limitation may not apply to you.
BROAN-NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE’S
OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER
THIS WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CON-
SEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH
PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which
vary from state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone
number stated below, (b) give the model number and part identification and (c) describe
the nature of any defect in the product or part. At the time of requesting warranty service,
you must present evidence of the original purchase date.
Broan-NuTone LLC Hartford, Wisconsin www.nutone.com 888-336-3948
REGISTER YOUR PRODUCT ONLINE AT
www.nutone.com/register
TYPICAL INSTALLATION
HOUSING
CEILING
JOIST, TRUSS,
OR I-JOISTS
MOUNTING
CHANNELS
GRILLE
CEILING
MATERIAL
POWER
CABLES
Housing mounted to joists, trusses, or I-joists.
Up to 24-inches on-center.

Other manuals for NuTone 765HFL

Question and Answer IconNeed help?

Do you have a question about the NuTone 765HFL and is the answer not in the manual?

NuTone 765HFL Specifications

General IconGeneral
Model765HFL
Air Flow100 CFM
Noise Level2.5 Sones
Voltage120V
Light TypeIncandescent
Sones2.5
Sound Level2.5 Sones
Light Wattage100 W
Duct Size4"

Summary

Read and Save These Instructions

Safety Warnings

Crucial safety precautions to reduce the risk of fire, electric shock, or injury to persons.

Cautionary Notes

Important notes for general ventilating use, mounting, and preventing motor damage.

Cleaning and Maintenance

Instructions for cleaning the unit, motor lubrication, and replacing the fluorescent lamp.

Operation

Warranty Information

Plan the Installation

Installation Steps

Insert Hanger Bars

Instructions for inserting and positioning the four sliding hanger bars.

Mount Housing

Steps for mounting the fan housing to the framing using hanger bars.

Attach Damper/Duct Connector

Procedure for attaching the damper or duct connector to the housing.

Install Ductwork

Guidance on connecting and running the 4-inch round ductwork.

Connect Wiring

Wiring Diagram

Diagram illustrating the electrical connections for the ventilator, heater, and light.

Connect Electrical Wiring

Instructions for running house wiring and connecting it to the unit's wiring plate.

Install Grille & Bulbs

Plug-in Light

Instructions for connecting the light plug from the grille assembly to the housing receptacle.

Attach Grille

Steps for attaching the grille assembly to the housing using an acorn nut.

Install Bulb

Procedure for installing the specified fluorescent lamp into the receptacle.

Attach Light Lens

Instructions for attaching the light lens back onto the grille.

Rotate Heater Grille

Service Parts

Related product manuals