NuTone 9093WH - User Manual

MODEL 9093WH
Page 1
MODEL 9093WH
DELUXE HEAT-A-VENTLITE
®
READ AND SAVE THESE INSTRUC TIONS
IMPORTANT INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE INSTALLING OR US-
ING THIS HEATER.
To reduce the risk of fire, electric shock, or injury to persons,
observe the following:
1. Use this unit only in the manner intended by the manufac-
turer. If you have questions, contact the manufacturer at the
address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the ser-
vice disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service
panel.
3. Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
4. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
5. This heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes, etc. and
curtains at least 3 feet (0.9 m) from the front of the heater.
6. Extreme caution is necessary when any heater is used by
or near children or invalids and whenever the heater is left
operating and unattended.
7. Do not operate any heater after it malfunctions. Disconnect
power at service panel and have heater inspected by a rep-
utable electrician before reusing.
8. Do not use outdoors.
9. To disconnect heater, turn controls to off, and turn off power
to heater circuit at main disconnect panel (or operate inter-
nal disconnect switch, if provided).
10. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening, as this may cause an electric shock or
fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or exhaust
in any manner.
12. A heater has hot and arcing or sparking parts inside. Do not
use it in areas where gasoline, paint, or flammable vapors or
liquids are used or stored.
13. Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
14. Install heater at least 6 inches from floor or any adjacent
wall.
15. To avoid electrical shock: Do not install unit in a tub or show-
er enclosure or any location where it may come in contact
with water. Never place a switch where it can be reached
from a tub or shower.
16. This product is designed for installation in ceilings up to a
12/12 pitch. Duct connector must point up. DO NOT MOUNT
THIS PRODUCT IN A WALL.
17. Do not connect heater to dimmer switch or speed control.
18. Ducted fans must always be vented to the outdoors.
19. This product must be grounded.
SAVE THESE INSTRUCTIONS

Summary

Important Instructions

General Safety and Usage Precautions

Covers intended use, hot surfaces, child safety, and operational guidance.

Electrical and Fire Safety Guidelines

Focuses on electrical safety, grounding, avoiding flammable areas, and fire prevention.

Installation and Location Requirements

Details installer qualifications, clearances, location rules, and venting.

Installation

Mounting to Open Joists

Steps for mounting the heater housing to ceiling joists in open framing.

Wiring

Completing Installation Steps

Final steps to connect the power unit and attach the grille and lens assembly.

Installation in Existing Construction

Instructions for installing the heater in existing ceiling construction, not new joists.

Maintenance

Bulb Replacement

Guidance on the type of bulbs to use for the heater and night light.

Lubrication Information

Information regarding permanent lubrication of the heater.

Cleaning Procedures

Steps for cleaning the heater grille and openings.

NuTone 9093WH Specifications

General

Brand	NuTone
Model	9093WH
Category	Air Conditioner
Language	English