- 10 -
10. TROUBLESHOOTING GUIDE
9. VACUUM POWER CONTROL
The hose handle is equipped with a control ring to regulate the air flow. The
control ring covers a “bleeder” hole. Open the hole to reduce the suction for cleaning
draperies, small rugs, and other light fabrics. Some very thick, plush carpets with
high density yarns also require reduced suction to make the nozzle easier to
push. Be sure to close the control ring completely over the hole to produce the
maximum power required for most other cleaning tasks.
PROBLEMS POSSIBLE CAUSES POSSIBLE REMEDY
1. Power unit
does not
start or
stops
suddenly.
• Defective inlet. Check other wall
inlets.
• Power unit overcurrent protector
has been activated.
• Blown fuse or tripped circuit
breaker on house electrical panel.
• Thermoprotector has been
activated.
• Defective hose.
• Replace defective wall inlet.
• Turn the unit off by using the
power switch on the unit. Check
the overcurrent protector button
located on the left side of the
power unit (push to reset the
system). Turn unit back on.
• Replace fuse or reset circuit
breaker on house electrical panel.
• Turn the unit off by using the
power switch on the unit. Wait
30 minutes to let the unit cool
down. Turn unit back on.
• Replace hose as required.
8. ACCESSORY KITS (CONT’D)
DELUXE ACCESSORY KIT INCLUDING (CONT’D):
• Deluxe tool set:
-12” wide hard floor brush with swivel
neck
-Stainless steel ratchet telescopic
wand; from a collapsed length of 25” to
an extended length of 41”
-Natural bristle upholstery tool
-Deluxe square faced dusting brush
-12” crevice tool with notched end
-Clip-on caddy
-Cloth caddy bag
To Next Page
Loading...
Need help?
General
