NUTOOL NCD12 - Re-chargeable batteries.; Self discharge; Battery Charging Indoors; Battery disposal

15
GB
isnotlessthan30to45minutes.
When charging a battery that has been discharged during
heavyuseallowthebatterytocooldownbeforecharging.Itis
recommendedthatthecoolingdownperiodisnotlessthan30
to45minutes.

NiCad batteries need to be recharged with a reasonable amount
ofcare,largelybecausetheycanbedamagedbyovercharging.
Overcharging can result in the battery temperature and internal
pressure to rise rapidly. This can cause the cells to distort
and lose electrolyte, and in extreme cases where the internal
pressureisextremelyhightheycanevenexplode.
This situation can also arise when an overcharged battery is
fittedtotheproductandisbeingused.
In order to avoid this extreme situation it is of vital importance
that NiCad batteries are fully discharged before charging and
that the charge time is not exceeded except when “Conditioning”
a new battery.  Repeated charging of partially discharged
batteriescouldcausefailureofoneormoreofthecells.

ANiCadbatterycanselfdischargeandloseitsstoredchargedue
tointernalchemicalaction.Typicallyitcanloseapproximately
10%ofitschargeinthefirst24hoursafterfullycharging,and
thenlosesitbyafurther10%permonth.

This charger is designed to be used indoors. We do not
recommendthatitisusedinsideyourhome.Ideallybatteries
shouldbechargedonabenchinaworkshop,garageorshed.
If the charging operation is to be carried out in your home the
area must be well ventilated and the charger must be placed
on a non combustible surface ensuring that the ventilation slots
arenotblocked.Neverexceedthechargingtimeexceptwhen
“Conditioning” a new battery, as this could damage the battery
andcharger.

When the battery fails to charge or maintain its charge, its
usablelifeisexhausted.Topreservenaturalresources,please
recycle or dispose of the battery pack properly. This battery
packcontainsnickel-cadmiumcells.Beforedisposalensurethat
the battery pack is fully discharged by operating your cordless
product then remove the battery pack from the drill housing and
cover the battery pack connections with heavy duty tape, to
prevent short circuit and energy discharge which could result in
afire.Donotattempttoopenorremoveanyofthecomponents.
Consult your local waste authority for information regarding
availablerecyclingand/ordisposaloptions.


Batteries may leak or explode if not charged or handled
correctly. Always observe the following precautions when
handlingbatteries.
Ensure that the machine is switched off before removing or
fittingbatteries.
Donotusethisbatterywithanyotherproduct.
Donotattempttofitthebatterythewrongwayround.
Donotshortout,orattempttodismantlethebattery.
Donotexposethebatterytoflamesorexcessiveheat.
Donotimmerseinorexposethebatterytowater.
Do not store or transport the battery with loose metal objects
suchdrillanddriverbits.
Batteries are prone to leakage when discharged. To avoid
damagetotheproduct,removeorre-chargethebatterywhen
nochargeremains.
Storethebatteryinacoolplacewhennotinuse.
After prolonged use the battery may become hot. Before
removing the battery, switch the machine off and allow the
batterytocooldown.
Do not use the battery if you notice any discoloration or distortion
ofthebatterycasing.

 During charging the battery will become warm as it is
beingcharged.
The battery supplied with this power tool contains a test charge
onlyandmustbefullychargedbeforeuse.
First read the safety instructions then follow the charging
instructions.
1. Connect the charger transformer lead into the charger
base.
2. Plugthechargerintoastandard230V~50Hzmainssocket
outlet.
3. Donotallowthecabletobecomeknottedorkinked.
4. Thischargerandbatterypackarespecificallydesignedto
worktogether.DONOTattempttochargeanyotherbrand
ofcordlesstoolorbatterypackwiththischarger.
5. Notethebatteryhasakeywaywhichallowsittofitintothe
chargeronlyoneway.
6. Placethebatterypackintothechargerbase.
7. Timethechargefor3(5-7)hoursonly.
8. Unplugthechargerwhennotinuseandstoreitinasuitable
storagecabinet.
9. Avoid charging your battery in freezing conditions as
chargingpowerwillnotbesufficient.
10.Whenchargingmorethanonebatterypackinsuccession
allowatleast30minutesforthechargertocooldownbefore
chargingtheadditionalbattery.
Alwaysremovethebatterypackandstoreit safelywhenthe
cordlessdrillisnotinuse.

Additional or replacement batteries specifically designed to
work with this drill and charger are available from your service
centre.