First Time Use
Working from left to right, atta ch the probes and p ow er adaptor
to the Nutradip GrowBoss.
Attaching th e pH Probe
The pH probe uses a twist-lock connector. Ensure the pins on
GrowBoss are aligned with the slot on the probe, and push firmly.
Twist the locking nut clockwise to tighten.
Attaching the Nutrient/Temperature Probe
The nutrient and temperature probe attaches in only
one direction. Ensure that the side of the plug that reads
“1394” faces up, and push firmly into place.
Attaching the Power Adaptor
Push the power adaptor barrel plug firmly into the GrowBoss
Preparing the pH Probe
1. Remove the protective liquid filled cap from the pH probe. Do
not touch the pH probe bulb. Put cap in a safe place. The pH
buffer solution is required for storage of the pH probe.
2. Gently shake the probe downward to remove any air bubbles
which may be trapped within the glass bulb.
Your Nutradip Growboss has been personally calibrated by a
trained service technician before leaving our assembly facility in
Kelowna British Columbia, Canada and arrives to you in ready-to-
use condition. However, we also recommend that calibration be
performed prior to initial use in the environment that the device will
be used most often to ensure the greatest possible degree of
accuracy from your new meter.
To Next Page
Loading...
Need help?
General