76
Please follow the cleaning
instructions before the first use,
and after each use. Cleaning the
nutribullet
®
is easy, simply place any
of the pieces (except for the motor
base and blade) on the TOP RACK of
the dishwasher or hand wash with
warm soapy water and rinse.
STEP 1: ALWAYS POWER OFF and
UNPLUG the motor base from the
outlet when cleaning. Do not attempt
to handle the appliance until all
parts have stopped moving!
STEP 2: Remove the cup|blade
assembly from the motor base.
STEP 3: Clean the individual
components as follows:
MOTOR BASE:
Use a sponge or dish cloth dampened
with warm soapy water to wipe down
until clean. If necessary, you may use
a small brush to scrub the actuator
system area to ensure it’s clean. To
avoid risk of injury, NEVER attempt
to clean the actuator system on the
motor base and do not attempt to
remove any pieces. NEVER submerge
the motor base in water.
BLADE:
Wash the blade with warm soapy
water and rinse, preferably
immediately after use in order to
avoid sticking of ingredients. Dry
completely, ensuring BOTH SIDES of
the blade are completely dried before
use. Never remove the gasket as this
will permanently damage the blade
Cleaning &
Maintenance.
The Golden Rules,
10 do’s and don’ts.
What’s included.
and cause leakage. If, over time, the
gasket becomes loose or damaged,
your extractor blade must be
replaced. We recommend replacing
your extractor blade every 6 months
(depending on use) or as needed for
optimal performance as the blade
dulls with use.
NUTRIBULLET
®
CUPS AND LIDS:
These parts are TOP RACK dishwasher
safe. We recommend rinsing them and
giving them a quick brush to remove
any dried debris before washing
them in the dishwasher. NEVER use
the sanitize cycle as this may warp
the plastic. Regularly check the tabs
on the sides of the cups for damage
(cracking, crazing, breakage or
rounding). If you notice damaged
tabs, discontinue use and replace
immediately to prevent possible
personal injury.actuator
NOTE: Do not attempt to repair or
service this appliance. If any of the
instructions or warnings are not
understood please contact Customer
Service for assistance at info@
freshnewbrands.com.
You may purchase new nutribullet
®
cups, blades and accessories at
nutribullet.com.
1. Always blend cold or room
temperature ingredients and
liquids (< 21°C).
2. Always allow the nutribullet
®
to
run less than 1 minute.
3. Carefully keep the outside and
inside of the blender clean, use a
damp cloth.
4. Take care of the 3 white rubbers
located in the upper part of the
power base.
5. Pay extra attention to the actuator
tabs in the upper edge of the
power base to loosen any sticky
debris from drips and spills. You
may use a damp cotton swab to
ensure these are kept clean.
6. Don’t overfill the cup to avoid
leakage. Stick to the maximum
quantity indicated by the MAX line
on the cup.
7. Always add liquid as one of your
ingredients!
8. Don’t wash the blade in
the dishwasher as elevated
temperatures may warp the
plastic and damage the gasket.
Never remove the gasket.
9. Do not use your nutribullet
®
,
its parts and accessories in a
microwave or freezer.
10. Replace your blade every 6
months or sooner to maintain
optimal performance. Signals that
it’s about time to buy a new blade:
in case of a bad smell, leakage
of brown or green liquid, louder
noise during blending, when
the gasket comes o the blade,
burning air (may also be novelty
after purchase) or if the machine
does not start (which can also be
caused by sticked activator tabs).
Note: It is quite normal for a brand
new appliance to produce an
unpleasant smell the first few times it
is put to use, we promise it will soon
smell delicious.
Customer Service
If you have any comments, questions,
warranty details, concerns, tips or
ideas:
email info@freshnewbrands.com.
!
Motor base 700mL
cup
Extractor
blade
To-go lid Manual
Drink ring
To Next Page
Loading...
