NUTRIBULLET Portable Blender - Safe Operation and Handling

54
Carry Lid by carefully
opening the Lid after
blending.
• If the Cup is hot or
warm to the touch,
the contents may
be HEATED and
PRESSURIZED.
If this happens, take
these steps:
- LEAVE ALONE, DO
NOT OPEN. Leave
the Cup where it is
and do not touch it or
allow others to touch
it. NEVER attempt
to separate the Cup
from the Motor Base
as this can result in
bodily injury.
- Do not blend again.
- Allow the Cup to cool
for at least 30 minutes.
If still warm, allow for
more cooling time.
- Once cool to the
touch, slowly open
the Lid, while pointing
away from your
face and body. Pour
contents out into a
separate vessel.
• ALWAYS ensure the Cup
is securely locked on
the Motor Base before
blending. The motor will
not turn on unless the
Cup is situated in the
locked position.
• ONLY operate the
unit with the Lid
cover in place.
• DO NOT exceed the
MAX line. Exceeding the
MAX line can result in
leakage or stop page of
the blade.
• DO NOT remove the
Cup or Lid while the unit
is in operation.
• DO NOT overfill the Cup
with ice as it may stop
the blades from turning
resulting in damage
to the unit or injury.
Always make sure the
liquid and ingredients
do not exceed MAX line
before blending.
• Do not use the Cup if
you detect cracking,
cloudiness, or
other damage.
• Do not attempt to
defeat any safety
interlock mechanisms.
• To avoid the risk of
electrical shock, fire or
bodily injury, DO NOT
charge or handle the
unit if it is wet, or in an
area that could get
wet, or handle with
wet hands.
• Do not charge your
device around
flammable materials,
on your bed or couch,
or on top of any type
of paper.
• Only charge your
device with the power
cord that came with
it. Using incompatible
parts or aftermarket
parts may damage your
nutribullet
®
Portable
Blender or create safety
hazards that may
cause personal injury
or damage.
• Do not use a rapid
charger or higher
wattage charger.
• Failure to take the
following precautions
can result in serious
personal injury, death
from electric shock or
fire, or damage to
your device.
• Don’t charge or store
batteries or devices
on combustible or
insulating surfaces
such as beds, sofas,
or carpet, and keep
them away from highly
flammable materials
such as blankets,
clothing, and paper.
• Do not charge in an
area of extreme
heat or cold.
• Only order replacement
parts from:
bulletbrands.com.au /
bulletbrands.co.nz
or by contacting
Customer Service:
AU: 1300 285 538 /
NZ: 0800 232 633.